TVS Apache RTR 160 4V Colours

Definitely the bike is capable of doing those distance, it comes to the rider and his willpower, unless you have a goal and covering long distance within short time might be less tiring for that higher cruising speed is required here the wind is not in favour to you as it is naked bike. so anywhere between 80-90 will be ideal for you. be scared of crosswinds from cars and big lorry that pass by you either it will push or pull you , at the end of the day not careful enough could make you smile in a photo frame to eternity

So my issue has been resolved by the service center guys recently, of course after having a lot of issues. Thankfully one of the technician was aware of this issue. So the fix was basically a software update of the FI system. And after that the bike has become more smooth and not more engine shutting off. So if you are going to the service center with the same issue and the technicians are not getting the issue exactly then you can suggest him to do this. There is something like a 4 port usb under the seat which the technician connected to to something and updated it from his mobile only.. If there is no issue anywhere else still your bike is facing the same issue then you can try this.

Faced same issue of shutting down the bike all of a sudden but it was starting after 20-30 minutes, once it was not even started, using starter multiple time resulted into battery failure and had to replace battery. Service center guys did push start of bike to take it to showroom that caused another impact of Display failure, I got display replaced but still there is problem like mode sensor does not work. It's been 2.5 years I am using the bike showroom guys did not even found the solution for bike shutting down issue as well as display issue, they were just restarting ECU and saying might need to replace ECU. Replacing ECU it will change whole wiring of bike. So I gave a try outside garrage , after showing to many people one guy found the issue, he said there would be carbon contamination over piston rings or over valves. So once he sprayed DW40 sprey into outlet pipe, it worked. After 6 months again same problem occurred this time he poured oil into compression chamber. by removing spark plug he poured the oil. This also worked.To get complete rid of the problem we might need to open the engine and clean up engine head and valves.